Bisphenol A removal from aqueous solution using fine α-Fe2O3 particles
Iron(III) oxide particles (α-Fe2O3) were obtained from ferrous chloride (FeCl3·6H2O) precursor using ammonium hydroxide as a precipitating agent and particles were calcined at 700 °C for 4 h. Morphological and structural properties of the obtained particles were determined using Scanning Electron Microscopy (SEM), BET/BJH analysis, X-ray diffraction (XRD) and Fourier Transform Infra-Red (FT-IR). The image analysis software, Image-Pro Plus 4.0, was used to determine the distribution of the diameter of the obtained particles. Hematite based particles were used as an adsorbent for BPA removal. Adsorption equilibrium was established after 75 min with 14.8% BPA removal efficiency.
S. Sakurai, A. Namai, K. Hashimoto, S.I. Ohkoshi: Am Chem Soc, 131 (2009) 18299–18303.
J. Shakhpure, H. Vijayanand, S. Basavaraja, V. Hiremath, A. Venkatraman: Bull Mater Sci, 28 (2005) 713–718.
M. Zhu, Y. Wang, D. Meng, X. Qin, G. Diao: Phys Chem C, 116 (2012) 16276–1628.
A.P. Alivisatos: Sci New Ser, 271 (1996) 933–937.
V.L. Colvin, M.C. Schlamp, A.P. Alivisatos: Nature, 370 (1994) 354–357.
A. Lassoued, M.S. Lassoued, B. Dkhil, S. Ammar, A. Gadri: Phys E Low-dimens Syst Nanostruct, 101 (2018) 212–219.
J. Xu, L. Wang, Y. F. Zhu: Langmuir, 28 (2012) 8418–8425.
B.S. Rubin: J Steroid Biochem Mol Biol, 127 (2011) 27–34.
J. Bohdziewicz, G. Liszczyk: Ecol Chem Eng S, 20 (2013) 371–379.
C.S. Guo, M. Ge, L. Liu, G.D. Gao, Y.C. Feng, Y.Q. Wang: Sci Technol, 44 (2010) 419–425.
G. Bayramoglu, M.Y. Arica, G. Liman, O. Celikbicak, B. Salih: Chemosphere, 150 (2016) 275–284.
T. Safabakhsh, H. Pourzamani: Int J Env Health Eng, 5 (2016) 25.
A. Bhatnagar, I. Anastopoulos: Chemosphere, 168 (2017) 885-902.
A. Lassoued, M. S. Lassoued, B. Dkhil, S. Ammar, A. Gadri: Physica E Low Dimens Syst Nanostruct, 101 (2018) 212–219.
D. Budimirović, Z. S. Veličković, V. R. Djokić, M. Milosavljević, J. Markovski, S. Lević, A.D. Marinković: Chem Eng Res Des, 119 (2017) 75.
Y. Xu, H. Bai, G. Lu, C. Li, G. Shi: J Am Chem Soc, 130 (2008) 5856–5857.
H. Liu, P. Li, B. Lu, Y. Wei, Y. Sun: Solid State Chem, 182 (2009) 1767–1771.
A. Lassoued, M.S. Lassoued, B. Dkhil, A. Gadri, S. Ammar: J Mol Struct, 1148 (2017) 276–281.
C. Namasivayam, S. Sumithra: Clean Technol Environ Policy, 9 (2007) 215–223.
X. Tang, P. Tang, S. Si, L. Liu: J Serb Chem Soc, 82 (2017) 39–50.
H. S. Park, J. R. Koduru, K.-H. Choo, B. Lee: J Hazard Mater, 286 (2015) 315–324.
J. R. Koduru, L. P. Lingamdinne, J. Singh, K.-H. Choo: Process Saf Environ, 103 (2016) 87–96.
Q. Zhou, Y. Wang, J. Xiao, H. Fan: Synth Met, 212 (2016) 113–122.
Copyright (c) 2018 Nataša Z Tomić, Marija M Vuksanović, Đorđe Veljović, Aleksandar Marinković, Vesna Radojević, Radmila Jančić Heinemann
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their published articles online (e.g., in institutional repositories or on their website, social networks like ResearchGate or Academia), as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
Except where otherwise noted, the content on this site is licensed under a Creative Commons Attribution 4.0 International License.